Turn signal switch & switch support
Turn signal switch with P/N61318048152AM will only fit with switch support with P/N32722072175. The original Magura switch support is too high, so the switch does not connect properly to the switch support. This leaves an opening visible.
Repair of idle mix screw thread
This video shows the repair of the idle mix thread: a thin alu-bronze bush of M8 / M7 x 0.75 is installed in the carburettor, realizing a very wear-resistant and strong thread Click this image to watch the video on Youtube:
Removal and installation of tappet guide bushings
In this video a method is shown to remove the old and install new tappet guide bushings from a 2 cylinder engine. The new bushings with an outer diameter of 24.97 mm have an interference fit with the crankcase. After installation, the bushings ID needs to be reamed / honed to give a tappet clearance of 0.02 – 0.04 mm Click this image to watch the video on Youtube: