Pistons aren’t round
It’s a wide spread misconception that pistons must be round / cylindrical. The opposite is true, This is a new Kolbenschmidt R27 piston 68.50 mm: From the Internet: Profile: If you roll a piston across a flat surface, you’ll notice it doesn’t roll in a straight line. This characteristic is called profile. Aluminum conducts heat significantly, so pistons are designed with a taper. The top of the piston (near the crown) has a smaller diameter than the bottom (near the skirt). The skirt itself is shaped like a barrel. This taper allows the
Read more »
Denfeld vs Pagusa saddle
The only difference between the Denfeld en Pagusa saddle is the saddle deck. There are small differences between the saddle deck frames: the shape of the frame and the front threaded bolt. The Pagusa saddle bolt it is a bit longer and has a spacer so that the front of the saddle deck sits +- 1.5 cm higher compared to the Denfeld saddle deck. The grain texture of the Denfeld rubber saddle deck surface is finer than the Pagusa grain texture. There is no quality difference All other parts are the same: subframe, Z-bracket, rubber spring, spring stop piece, mounting
Read more »
Light and horn switch, left side – quality issue
The Light & Horn Switch with P/N 61 31 8 048 162 does not properly fit on the Clutch Lever Assembly with P/N 32 72 2 072 112 The cause of this problem is clarified in the photos below. The ends of the switch housing extend too far into the clutch lever assembly. As soon as both parts are mounted together on the handlebar, the switch housing is pushed outwards, so that the switch housing can no longer be hooked behind the cam. Here a comparison between an original Bosch and after-market switch housing on a /2 clutch assembly