Products
- Armature 60W for 17 mm taper, rewound, in exchange
- Float housing cover, complete - Bing 32-310-112 ►see details
- Complete set of gaskets & seals for R24 - R25 engine ►see details
- Voltage regulator 12V - mechanical
- Holder for regulator and diode plate 12V three-phase (N.L.A.)
- Rear shock absorber - HAGON ►see details
- Shock absorber, front suspension +Mark+Swiss (ATOS) ►see details
- Rear shock absorber +Mark+Swiss (ATOS) ►see details
- Footpeg rubber
- Muffler "Swallow" R25/2 - original look, optimimal performance ►see details
- Clamp 45 mm for rubber boot, upper - SSt
- Hose clamp 20 - 32 mm for rubber boot, lower - SSt
- Shifting fork (NOS)
- Cylinder head LH side
- Muffler "Torpedo" - R25/3 - optimized for performance
- Exhaust header clamp R25/3 - polished SSt
- Tank Cure - rust remover 200 ml
- Retainer with pressure ball & spring, front brake cable - polished SSt
- Hex head bolt M8 x 32
- Hook wrench for exhaust nut Matra 338-1
- Field coil 1 - 4 for 6V 45/60W generator - oval core ►see details
- Crankcase vent tube - polished SSt
- Hardy disk complete - SSt sleeve (not polished)
- PostNL 0 - 2 kg World (non-EU) without insurance
- Wave washer A10 - SSt
- Switch mounting crown, in headlamp ►see details
- Allen head screw for shift fork M8 x 45 - zinc plated ►see details
- Lens head countersunk screw M5 x 18, Kickstarter - SSt
- Battery 6V 12Ah Blitz 0811 - maintenance free (no shipment outside mainland Europe) ►see details
- Brake lining for half hub, w/o rivet holes - 25 x 4 x 192 - Beral "Grün" NON-ASBESTOS
- Speedometer cable
- Clutch spring compressor M6 - SW14, set of 3 - Matra 357a
- Puller for coupling flange R20 - R27, R5 - R68
- Idle mix screw, Bing 50-920, over-size M8 / M7 x 0.75 ►see details
- Screw cap main jet Bing 50-250, over-size M15.5 x 1,
- Grease nipple AM6 x 1, old form, for throttle housing - SSt
- Throttle housing cover, after-market
- Wing nut for rear brake rod - polished brass
- Grease nipple M6 x 0.75 - Zinc plated
- Hex bolt M8 x 30 - SSt
- Used part: Gearbox cover (price & availablility on request)
- Muffler "Fish tail" R25 - optimized for performance (available for pre-order)
- Hex bolt M8 x 1.25 x 20 - SSt
- Hex bolt M8 x 30 for handlebar riser
- Rubber buffer in rear suspension, upper - 12 mm
- Muffler "Swallow" with mounting bracket - RH - optimal perfomance ►see details
- Muffler "Swallow" with mounting bracket - LH - optimal performance ►see details
- Headlamp bucket - after market ►see details
- Headlamp complete, w/o speedometer
- Headlamp complete, w/o speedometer - after market ►see details
