Products
- Bell cover on drive shaft - blasted aluminum R25/3
- Bell cover on drive shaft - polished aluminium R25, R25/2
- Needles for pinion bearing
- Seal gearbox input shaft 30 x 40 x 7 (LYO)
- Main jet 135, Bing 44-031 (D~1.22 mm)
- Collar bolt for front wheel stand - polished SSt
- Thrust rod (foot brake lever - angle lever) - SSt polished
- Rear main bearing holder, L=29.5 mm + 0.015 mm oversize outside ►see details
- Rear main bearing holder, L=32.0 mm + 0.015 mm oversize outside ►see details
- Service: final drive - renewal of rubber disk / bell cover on drive shaft ►see details
- Support spring for idle switch
- Spring for brake foot lever - polished SSt
- Spring seat fiber washer
- Throttle cable seat (2 cables)
- Rear fender, base coated - NOS (price & availability on request)
- Brake adjusting bolt - SSt
- Used part: valve cover R25/2 (price & availability on request)
- Used part: valve cover R25/3 (price & availability on request)
- Knee pad rubber on fuel tank, right side - R26, R27
- Hex head screw M10 x 1 x 42, upper side front shock - SSt
- Hex head screw M10 x 1 x 42, upper side front shock - zinc plated steel
- Hex head screw M10 x 1 x 48, lower side front shock - zinc plated steel
- Used part: gearbox R51/3 - R68 (price & availability on request)
- Wheel bearing assembly - ready to be installed, R26 - R27
- Compression ring 1.9 mm for crown gear
- Compression ring 2.1 mm for crown gear
- Hardy disk, after-market, T~25 mm
- Spoke nipple M3.5, chrome, after-market (WWS)
- Bearing FAG 6205 C3 - input shaft, front
- Bearing FAG 6304-H C3 - output shaft front and rear
- Battery strap, rubber, L = 260 mm - w/o BMW logo - after market
- NORMA carburetor / air tube clamp 42 mm - zinc plated
- Washer - SSt
- Cylinder head RH side
- Bosch sticker for battery housing - D = 53 mm
- Valve cover (thin ribs), R50/2 - R60/2 Top Quality ►see details
- Roller for conrod Ø 7.020 x 10 mm ±1μ
- Oil pan gasket - cork, R5 - R51/2
- Set of plugs for generator housing R24 - R26 (4 pcs)
- PIug cover for wheel hub, for felt ring - untreated steel ►see details
- PIug cover for wheel hub, for felt ring - polished SSt ►see details
- Sliding claw gearbox - after market
- Shim for input shaft 1.0 mm
- Complete tapered roller bearing set, ready for installation
- Protective sleeve on drive shaft - aluminum blasted (>09-1953)
- Protective sleeve on drive shaft - chrome plated steel (<09-1953)
- Lens head countersunk screw - polished SSt
- Round exhaust nut, chrome
- Shock absorber, front suspension R26, R27 +Mark+Swiss (ATOS) ►see details
- Hex bolt M8 x 1 x 110 for fuel tank - polished SSt
