Products
- Knee pad R5 - R71, set of 2
- Double connection for Frankfurter model with filter
- Fuel tank R26 & R27, painted & coach-lined (not available anymore)
- Foam rubber pad for battery support
- Battery bracket (lower) - SSt
- Battery holder R25
- Battery bracket (upper) - SSt (available for pre-order)
- Speedometer drive shaft in gearbox
- Spur gear 1st speed 36T - R51, R51/2, Ø=95,0 (available for pre-order)
- Ball bearing FAG 6303 - front wheel R24
- Spacer, front hub (available for pre-order)
- Spacer bush, front hub, L=11.5 mm (available for pre-order)
- Clutch lever spring - SSt polished
- Cover for carburetor L/R (for M38 cover ring) ►see details
- Bend for carburetor cover Bing 55-205-01
- Hex nut for engine/center stand bolts M12 x 1.5 zinc plated
- Eber tail light, without brake light ►see details
- Eber tail light, without brake light lens, with 2 phase bulb socket ►see details!!
- Universal joint 17 x 41 for R25 - R25/3
- Speedometer Veigel, 0 - 160 km/h, W=1.15, final drive 32:7
- Float 7 gram, plastic, after-market
- Rubber washer for air filter screw
- Oversized M5.2 - 5.3 x 14.5 mm hex screw for float chamber cover, Bing 40-528
- Rivet for brake lining 4 x 12 mm - half hollow
- Float housing cover, old model, after-market ►see details
- Spoke M4 x 210 - chrome - single butted
- Ball bearing FAG 6208 for rear drive R24
- Bolt M8 x 1 x 12
- Hub R35, R20, R23, R24 (discontinued)
- Wrist pin bushing - 20 mm (needs reaming after press fit)
- Lens head screw M5 x 10, for old model switch adapator
- Carburetor air tube clamp
- Gasket set carburetor R50/2 - R69S
- Carburetor: boring carburetor tube for oversized slide R50/2 - R69S
- Light grey rubber ring on drive shaft - outer D = 45 mm (<09-1953) ►see details!!
- Protection cover on cardan housing, OD 23 mm - polished SSt
- Ventilation dome cpl. for subsequent installation, cap OD 19 mm, M14 X 1.5 - SSt ►see details
- Spring for rear brake rod - polished SSt
- Hex nut for flywheel - zinc plated
- Telescopic eye, lower, aluminum
- PostNL shipping costs
- Gasket for gear box bearing cover (0.5 mm)
- Felt ring for wheel hub cover
- Bearing FAG 1303 for rear wheel hub R24
- Spacer for rear wheel hub
- Spark plug NGK B7ES long reach (equiv. to Bosch W260T2 / W3CC)
- Hex bolt M12 x 1.75 x 25 for rear footpeg - SSt
- Threaded insert Bing 50-390
- Spoke fitting gauge (R25/3 - R27, R51/3 - R68 full hub) ►see details
- Wave washer B8 - galvanized
