Products
- Tappet guide R27 - chrome plated steel
- Seal ring in left side wheel hub 25 x 35 x 7
- Flat washer Ø 6.4 - OD 14 mm - SSt
- Alu rivet - round head 2 x 5, for oil felt on leaf spring (contact points)
- Denfeld saddle complete with rubber seat spring (no longer available)
- Cuff (seal) kickstarter R5 - R51/2
- Serrated washer J5.3 - zinc plated
- Drift bushing for seal - input shaft
- Drift bushing for crankshaft seal (17 mm taper)
- Drift bushing for crankshaft seal (20 mm taper)
- Drift bushing for camshaft seal ►see details
- Stop washer R3, R4 (S5), R35 (no std. stock item)
- Tappet R3, R4 (S4 & S5), R35 (no std. stock item)
- Coupling bell R60/6 - R100RS
- Speedometer VDO, W=1.08, final drive 27:6
- Press bolt for drive shaft flange - Matra 281/1
- Press bush for drive shaft flange - Matra 281/2
- Support bushing for drive shaft Ø 15 mm, r = 5 mm Matra 281/3
- Ring holder Matra 331/2 for pressing driveshaft
- Carburetor slide cover plate, RH side, Bing 30-322, after-market
- Carburetor slide cover plate, LH side, Bing 30-320, after-market
- Carburetor slide cover - after market
- Stickers for air filter H93L (set of 2 pcs)
- Return spring
- Coupling nut (upper) M16 x 1 for fuel tap with filter cup
- Tap M8 x 1.25 - LH thread - Dormer
- Retainer WITHOUT pressure ball & spring, front brake cable - zinc plated
- Used part: brake shoe, front ►see details
- Used part: drive shaft - 1:5 taper - thread M14x1.5 - with key way
- Lever for thrust rod, rear brake
- Clutch lever housing - after market ►see details
- Clutch lever housing with thread for mirror- after market ►see details
- Service: crankcase - measurement of distribution gears & reaming of rear bearing holder
- Seal for wheel bearing cover 36 x 22 x 8
- Neutral light fixture, green ►see details
- Service: crankcase - reaming of tappet guide bushing
- Front fork seal R50/5 - R100RS
- Services: small materials usage & packaging
- Black rubber disk on drive shaft - outer D = 54 mm
- Final drive tool set V504
- Copper seal ring C18 x 24 x 2 mm
- Foot shift rubber - black
- Valve guide exhaust, L = 50 mm Ø 13.10 mm (countersunk)
- Valve guide exhaust, L = 50 mm Ø 13.15 mm (countersunk)
- Valve guide exhaust, L = 50 mm Ø 13.30 mm - countersunk (available for pre-order)
- Gasket - front cover kickstarter shaft R11 - R17, R52, R57, R62, R63
- Clamp 70 mm for rubber on drive shaft boot, original form - SSt
- Clamp for ignition coil
- Stop plate for horn bracket R50S, R69S
- Horn bracket R50S, R69S
